Robomaid RM-770 Manuel d'utilisateur

RM-770 ROBOT VACUUM CLEANER

How to Use The Virtual Wall Before using the Virtual Wall, install the batteries as shown in Figure 3, open the bottom cover of the Virtual Wall,

Using the Mopping Attachment• The mopping cloths can be used dry or damp.• Attach the specially designed Robomaid mopping cloth to the mopping holder.

Cleaning Sensors• The sensors should be cleaned by cotton swab or soft cloth.• There are wall-following sensors installed in the front of bumper of th

Main BrushHow to Install the Main Brush• Align the brush with the brush motor by inserting the square end of the brush into the main brush motor.• Ins

If the above errors cannot be resolved, please contact Robomaid Customer Care.TroubleshootingIf you experience some issues while using your Robomaid R

Technical SpecicationsModelDimensionsWeightSpeedCharging TimeOperation TimeNoise GradeInputRated PowerMade in ChinaRobomaid RM-770Diameter: 35cm He

Due to continual product improvement in design or otherwise, the product you purchase may dier slightly from the illustrations in this book.Copyright

Thank you for purchasing the Robomaid RM-770 Robot Vacuum Cleaner. Please read this manual carefully before using this product.No one other than ocia

ComponentsPower AdaptorRM-770 Robot Vacuum Cleaner Docking Station Remote ControlMopping Attachment(2 x cloth and holder)User ManualDVDQuick Start Gu

Names of PartsDocking StationOn/O ButtonInfrared TransmitterPower Adaptor SocketCharging TerminalsSkidproof Floor PadsFull Go ButtonClock ButtonAdjus

Standby Mode Docking ModeIf the Robomaid runs completely empty, it may not charge from the Docking Station and must be charged by the Power Adapto

Charging Mode Please take care when plugging inPower Adaptor!2 erugiF 1 erugiF 4 erugiF 3 erugiF 1. Take out the battery before disposing of the

AUTO Modes:1 – The Robomaid will run until the battery is fully used and then enter Docking Mode.2 – The Robomaid will run for 30 minutes and then sto

• Press this button again to enter Standby Mode.How to use the Remote Control:The Power Button “ ”• When the Robomaid RM-770 is switched on, press

How to use the Docking Station:Connect the Power Adaptor to the Docking Station. The display will show the time and day as being Monday 8:00 am. Ther