Cleaning Sensors
• The sensors should be cleaned by cotton swab or soft cloth.
• There are wall-following sensors installed in the front of bumper of the Robomaid RM-770, and ground
detection sensors installed under the RM-770 (see the gure below)
To ensure a more eective cleaning of the Robomaid RM-770, please
clean the sensors regularly.
How to Replace and Clean the Filters
Removal and Cleaning of Filters:
• Hold the middle part of the lter tray located on the inside of the dustbin (See gure 1) and then
slide out (See gure 2).
• The lters will easily lift out (See gure 3)
• Unclip the rear iter grill (See gure 4).
• Take out the lter inside (See gure 5).
• The lters can be cleaned in water and then reused after drying. It’s recommended to clean and
replace them regularly.
• Install the 2 large lters onto the lter tray then slide it into the dustbin. Install the softer lter rst. (Figure 1)
• First install the lter in the lter grill (Figure 5), and then insert the top end into the dustbin, and then clip
the lower end in place.
Figure 1 Figure 2
Figure 3
Figure 4 Figure 5
Side Brush
• To remove, simply unscrew the screw and release the side brush.
• To Install, align the side brush with the mount and press it down (See Figure 1)
Use the screwdriver and screw to fasten the side brush until tight.
Figure 1
Installation of Filters:
11
Commentaires sur ces manuels